川消_萃联
气体灭火系统
自动喷水灭火系统
当前位置:首页 > 新闻中心您对川消灭火器的维护了解多少?

您对川消灭火器的维护了解多少?

来源:http://www.cx-fire.com/ 日期:2022-09-20

在我们的生活和工作中,我们经常可以看到灭火器的存在。一旦发生火灾,我们就离不开灭火器的帮助。那么,你对灭火器的维护了解多少?下面川消小编为您解说。
In our life and work, we can often see the existence of fire extinguishers. In case of fire, we can't do without the help of fire extinguishers. So, how much do you know about the maintenance of fire extinguishers? Now let's explain it to you.
灭火器的回收
Recovery of fire extinguisher
从喷雾干粉灭火器中除去的剩余灭火剂应根据ABC干粉和BC干粉灭火剂进行回收和存储。这种灭火剂不能用于再充装;从从未喷射过的干粉灭火器中的灭火剂,应根据灭火器铭牌上指示的灭火剂成分分别回收。符合相关灭火剂标准,无异物后,可用于补充。
The residual extinguishing agent removed from the spray dry powder extinguisher shall be recycled and stored according to ABC dry powder and BC dry powder extinguishing agents. This fire extinguishing agent cannot be used for recharging; The extinguishing agent removed from the dry powder extinguisher that has never been sprayed shall be recycled according to the composition of the extinguishing agent indicated on the nameplate of the extinguisher. Comply with relevant fire extinguishing agent standards, and can be used for supplement when there is no foreign matter.
洁净气体和二氧化碳灭火器中的灭火剂应按照要求进行处理,用于回收时,应检查其纯度和水分含量。检查符合相关灭火剂标准后,可用于再充装。
The extinguishant in the clean gas and carbon dioxide extinguisher shall be disposed according to the environmental protection requirements. When it is used for recovery, its purity and moisture content shall be checked. It can be used for recharging after checking that it conforms to relevant fire extinguishing agent standards.
水压测试
Hydrostatic test
对确认不属于报废范围的灭火器气瓶(筒体)、贮气瓶,或可不更换的器头(阀门),装有可间歇喷射装置的喷射软管组件,以及气瓶(筒体)与器头(阀门)的连接件等应逐个进行水压试验,对二氧化碳灭火器的气瓶应逐个进行残余变形率的测定。
Water pressure test shall be carried out one by one for the fire extinguisher cylinder (cylinder), gas storage cylinder, or the head (valve) that can not be replaced, the spray hose assembly with intermittent spraying device, and the connection between the cylinder (cylinder) and the head (valve) that are confirmed not to be scrapped, and the residual deformation rate of the carbon dioxide fire extinguisher cylinder shall be measured one by one.
水压试验应按照灭火器铭牌上规定的水压试验压力进行。水压试验期间,不得有渗漏,部件掉落,开裂和明显的宏观变形,二氧化碳灭火器钢瓶的残余变形率不应大于3%。
The hydrostatic test shall be conducted according to the hydrostatic test pressure specified on the nameplate of the fire extinguisher. During the hydrostatic test, there shall be no leakage, parts falling, cracking and obvious macroscopic deformation. The residual deformation rate of carbon dioxide extinguisher cylinder shall not be greater than 3%.
经水压试验合格的零部件应清洗干净,清洗不应使用有机溶剂。
Parts and components that pass the hydrostatic test shall be cleaned, and organic solvent shall not be used for cleaning.
川消
零件更换
Parts replacement
维修机构应根据灭火器装配图和原始灭火器制造商的可更换零件清单更换零件。灭火器气瓶(管)不能更换。
The maintenance agency shall replace the parts according to the fire extinguisher assembly drawing and the replaceable parts list of the original fire extinguisher manufacturer. The fire extinguisher cylinder (pipe) cannot be replaced.
替换零件应与原始灭火器制造商提供的零件特性一致。
Replacement parts shall have the same characteristics as those provided by the original extinguisher manufacturer.
对于通过水压测试的气瓶(气瓶),如果外部涂层的一部分脱落,但没有生锈,则可以使用其他涂层。附加涂层应光滑,平整,颜色一致,无气泡,流痕,皱纹等不足,附加涂层不应覆盖铭牌。
For cylinders (gas cylinders) that have passed the hydrostatic test, if part of the external coating falls off, but there is no rust, other coatings can be used. The additional coating shall be smooth, flat, consistent in color, free of bubbles, flow marks, wrinkles and other defects. The additional coating shall not cover the nameplate.
在每次维护期间,应更换以下零件:密封片,圈,垫等密封零件;水基型灭火剂;二氧化碳灭火器的超压膜片。
During each maintenance, the following parts shall be replaced: sealing pieces, rings, gaskets and other sealing parts; Water based extinguishing agent; Overpressure film of carbon dioxide extinguisher.
此外灭火器应拆除,并采取必要的防护措施,只有在确认灭火器内部没有压力时,才能拆卸灭火器的头部或阀门。更多相关事项就来我们网站http://www.cx-fire.com咨询吧!
In addition, the fire extinguisher shall be safely removed and necessary protective measures shall be taken. Only when it is confirmed that there is no pressure inside the fire extinguisher can the head or valve of the fire extinguisher be removed. Come to our website for more information http://www.cx-fire.com Consult!
上一篇:灭火器使用时的再充装要点了解
下一篇:大空间场所适合安装探测器的优点

相关产品 / Related products