手抬机动消防泵组整机由水泵、引水器、汽油或柴油发动机组成，具有引水结构紧凑、轻便等特点。手抬机动消防泵引水困难怎么回事？下面川消小编为你讲解一番。

The whole set of hand lift motor driven fire pump is composed of water pump, water diverter, gasoline or diesel engine, which has the characteristics of compact and light water diversion structure. Why is it difficult to carry the motorized fire pump to divert water? Now Chuanxiao will explain it to you.

1.吸水高度高于7米，降低吸收高度。

1. If the water absorption height is higher than 7m, reduce the absorption height.

2.吸水管滤堵塞，清理滤网。

2. The suction pipe filter is blocked, and the filter screen shall be cleaned.

3.吸水管密封胶圈损坏，更换密封胶圈。

3. If the sealing rubber ring of the suction pipe is damaged, replace it.

4.吸水管中部出现裂缝、洞空，更换吸水管急用可以将吸水管完全放入水中。

4. There are cracks and holes in the middle of the water suction pipe, and the water suction pipe can be completely put into the water when replacing the water suction pipe for emergency.

5.排水阀未关闭。关闭排水阀。

5. The drain valve is not closed. Close the drain valve.

6.真空泵润滑油缺少，加注润滑油。（注意：严禁无润滑油使用真空泵吸收，严禁用水代替润滑油）。

6. The vacuum pump is short of lubricating oil, so add lubricating oil. (Note: It is strictly prohibited to use vacuum pump to absorb without lubricating oil, and it is strictly prohibited to replace lubricating oil with water).

7.整机在使用过程中倾向高度不能超过15°，存放不得超过35°。

7. The inclination height of the whole machine during use shall not exceed 15 °, and the storage shall not exceed 35 °.

开机：启动发动机，带动水泵叶轮高速转动，通过真空泵真空或者排气式真空在≦30秒之间把水从进水管引入水泵，通过水泵叶轮的高数转动产生压力，再通过水泵出水口排水。有怎样的需求就来我们网站http://www.cx-fire.com看看吧！

Start up: start the engine to drive the pump impeller to rotate at a high speed, introduce water from the inlet pipe to the pump through the vacuum pump or exhaust type vacuum within ≤ 30 seconds, generate pressure through the high rotation of the pump impeller, and then discharge water through the pump outlet. Come to our website if you have any needs http://www.cx-fire.com Look!