川消_萃联
气体灭火系统
自动喷水灭火系统

联系我们

  • 萃联(山东)消防设备有限责任公司
  • 电话:15508683119
  • 地址:山东省济南市历城区祝舜路44号
当前位置:首页 > 新闻中心消防水泵使用的具体优势你知道吗?

消防水泵使用的具体优势你知道吗?

来源:http://www.cx-fire.com/ 日期:2022-04-26

消防水泵基本是由叶轮,泵体,泵轴,轴承,密封环,电机等组成的。消防水泵是水灭火系统中的一个重要组成部分,其特点是平时长期不用,一旦使用就要100%发挥作用,由于长期处于闲置状态,加上泵房的环境潮湿,很容易发生消防泵轴和叶轮锈蚀、锈死和电气元件不能正常使用的现象,以发生火灾时,消防泵不能正常运转,无法扑灭火灾,危害了人民群众的生命财产。
The fire pump is basically composed of impeller, pump body, pump shaft, bearing, sealing ring, motor, etc. The fire pump is an important part of the water fire extinguishing system. It is characterized by not being used for a long time. Once it is used, it will play a role 100%. Due to the long-term idle state and the humid environment of the pump room, it is easy to cause the corrosion and death of the fire pump shaft and impeller and the abnormal use of electrical components, so that the fire pump can not operate normally and extinguish the fire in case of fire, Endangering the safety of people's lives and property.
1、设备具有全自动巡检功能,巡检周期7天以内按客户要求任意设定,通常设为每周期24小时;
1. The equipment has full-automatic inspection function. The inspection cycle is set arbitrarily according to the customer's requirements within 7 days, usually 24 hours per cycle;
2、消防泵在巡检时以低频低速方式逐台启动巡检运行,每台泵运行时间不少于2分钟,通常设为每周期5分钟;
2. During patrol inspection, the fire pump shall start patrol inspection operation one by one in the mode of low frequency and low speed. The operation time of each pump shall not be less than 2 minutes, which is usually set to 5 minutes per cycle;
川消
3、自动巡检时,对消防泵控制柜的一次回路中主要低压器件给出不大于2S的脉冲动作信号,逐一检查其动作状态;
3. During automatic patrol inspection, the main low-voltage devices in the primary circuit of the fire pump control cabinet shall be given a pulse action signal of no more than 2S, and their action status shall be checked one by one;
4、自动巡检时,当遇消防信号时立即退出巡检,马上进入消防运行状态;
4. During automatic patrol inspection, exit the patrol inspection immediately in case of fire signal and enter the fire operation state immediately;
5、自动巡检时,若发现故障则发出声、光报警并记忆和储存Z少25条故障信息;
5. During automatic patrol inspection, if a fault is found, an audible and visual alarm will be sent, and 25 fault messages will be memorized and stored;
6、具有过电压、过电流、短路、缺相等保护功能;
6. It has overvoltage, overcurrent, short circuit and fault protection functions;
7、消防巡检过程中不对管网产生压力,有效保护管网;
7. During fire patrol inspection, no pressure will be generated on the pipe network to effectively protect the pipe network;
8、短信告警功能;
8. SMS alarm function;
9、设备预备RS485通信接口,可完成对楼宇自控的运行状态远传;
9. The equipment is equipped with RS485 communication interface, which can complete the remote transmission of the operation state of building automatic control;
10、试水单元功能;
10. Function of water test unit;
11、水池液位及管道水压告警功能。
11. Alarm function of pool liquid level and pipeline water pressure.
上一篇:气体灭火系统的防护区要求是什么?
下一篇:电控消防水炮怎么进行灭火?

相关产品 / Related products