川消_萃联
气体灭火系统
自动喷水灭火系统
当前位置:首页 > 新闻中心消防水炮在安装过程中需要注意的事项

消防水炮在安装过程中需要注意的事项

来源:http://www.cx-fire.com/ 日期:2023-02-28

1、消防水炮安装支架必须稳固,安装支架需要防震防晃动,消防水炮在转动和喷水的时候不能晃动。
1. The mounting bracket of the fire water monitor must be stable. The mounting bracket must be shockproof and anti-shaking. The fire water monitor cannot shake when rotating and spraying water.
2、要严格执行国标规范,以方便后期通过消防验收。
2. It is necessary to strictly implement the national standards and specifications to facilitate the later acceptance of fire control.
3、在安装调试过程中消防水炮如果做出错误动作,应及时按下现场操作盘的急停按钮,切断电源,并查找原因。
3. If the fire water monitor makes wrong action during installation and commissioning, press the emergency stop button on the site operation panel in time, cut off the power supply and find out the cause.
川消
4、在安装调试现场,避免有强电磁场辐射,以及电气焊或者明火作业,如不可避免,应将消防水炮系统切换手动状态,并进行参数调整。
4. At the installation and commissioning site, avoid strong electromagnetic field radiation, electric welding or open fire operation. If it is unavoidable, switch the fire water monitor system to manual mode and adjust the parameters.
5、吊装川消消防水炮时,应妥善保护消防水炮炮头传感器,防止传感器受损失灵。
5. When hoisting the fire water monitor of Sichuan Fire Fighting Company, the sensor of the fire water monitor head shall be properly protected to prevent the sensor from damage and failure.
6、消防水炮的线束在安装后要整理整齐,并留有一定的余量,方便消防水炮转动探测,线束在消防水炮转动的时候不能产生摩擦现象。
6. The harness of the fire water monitor shall be tidy after installation, with a certain margin to facilitate the rotation detection of the fire water monitor. The harness shall not produce friction when the fire water monitor rotates.
如果我们不熟悉消防水炮相关组件功能和注意事项,贸然安装,很容易造成消防水炮系统组件在安装过程中受损,影响整个系统,导致安装过程延长时间。在安装过程中如果遇到其他问题,应及时和厂家技术人员进行沟通,在厂家技术员指导中进行消防水炮系统安装。更多相关内容就来我们网站http://www.cx-fire.com咨询!
If we are not familiar with the functions and precautions of the relevant components of the fire water monitor and install it hastily, it is easy to cause damage to the components of the fire water monitor system during the installation process, affect the entire system, and prolong the installation process. In case of other problems during installation, timely communicate with the manufacturer's technicians and install the fire water monitor system under the guidance of the manufacturer's technicians. Come to our website for more relevant content http://www.cx-fire.com consulting service
上一篇:高压二氧化碳灭火系统工作时的动作程序
下一篇:自动跟踪定位射流灭火系统的范围与设计

相关产品 / Related products